SMT 479 specs and pictures

colej This is inexcusable at any price. I've returned a set of Dynacraft Prophet Muscle Blades because the faces were not flat. This is the reason Golfworks will not check or publish MPF of Hireko irons.

colej

Well, the 9 iron is reasonably close if you want it a bit flat. (assuming the face is flat).

colej

Bulge & Roll....

colej Too much juice injected? Probably better cut one open.

colej You’re gonna advertise as a premium head the freaking faces should be flat!?!?

1 of my bosses wasn't paying attention 1 night, while installing a new front door in his own house. He showed me the next morning... the diff between what 'expanding foam' would be expected to do.....& exactly what 'triple expanding foam' would do. He did this for a living.

Had to cut the whole frame out, that door would not budge!

. Thanks for posting the specs!

Back when I had my shop Hireko and Diamond Tour where two I didn’t buy much from. I looked at them as bottom line. Now , other than Golfworks they’re all that’s left.

Par4QC Soooo, are you indeed confirming that when you cut that head you have open that ‘foam’ is in there?

Someone must have found a 'cheap' foundry in China.....you get what you pay for!

You know, I've never thought to check if a iron face was flat, just assumed they would always be flat. Interesting!

pellmell

I’m thinking there might be different reason for this.

Jeff, have another look, for me, if nothing else. When you put the flat edge on the face, where does the bulge actually start? It's not humped, in the middle, is it (on all/any)? Are the faces flat except for the last 4-5 scorelines (from toe/topline)?

My AW shows what I just described, flat from leading edge to 5th line down at toe, and has got me wondering if they are not, in fact, supposed to be that way. What with a 'rebound' type face. And, it really couldn't be called a 'bulge' if this is the case.

Thanks for the info but could you please rotate your photos 90°?