Maltby club heads, PXG driver head, swing science 3 wood head

I just ordered an MCS70 for that Swing Science 3 wood head.

Here is a link:https://www.valuegolf.com/mcs-70-orange-graphite-wood-shaft.html

thanks. I figure if it doesn't work out in the driver, I can pull the shaft and tip it for a fairway wood.

Subsonic
I have tried the MCS iron shaft. Heavy and stiff shaft. Research your tipping instructions, before cutting. 2 different tipping instruction from different sellers. Coating chips easily.

sloppytypist I use the instructions off Value Golf website. Which ones do you use?

Subsonic I just ordered an MCS70 for that Swing Science 3 wood head.

That's a good frwy wood head "hot" and good "feel".

Jelopster I have the blue in a 5 wood. I went with the orange in a 3 wood because it has a slightly higher trajectory. Figured that would help a little with getting the 3 wood airborne.

it's been 5 years since I worked with this Shaft... I can't recall
I would soft step 1" to start.
Monark golf says it is a low launch shaft.

Subsonic

I have the MCS 75 blue in my Eye 2 irons and GigaGolf forgings. A bit heavy for me but I soft - stepped them. They launch pretty good.