• Buy/Sell

  • Maltby club heads, PXG driver head, swing science 3 wood head

sloppytypist

You could do that. Traditionally the fairways and utility woods would have slightly heavier shafts then the driver. Doesn’t mean you can’t do it, especially if you have a nice smooth tempo.

    thanks. I figure if it doesn't work out in the driver, I can pull the shaft and tip it for a fairway wood.

    Subsonic
    I have tried the MCS iron shaft. Heavy and stiff shaft. Research your tipping instructions, before cutting. 2 different tipping instruction from different sellers. Coating chips easily.

        Subsonic I just ordered an MCS70 for that Swing Science 3 wood head.

        That's a good frwy wood head "hot" and good "feel".

          Jelopster I have the blue in a 5 wood. I went with the orange in a 3 wood because it has a slightly higher trajectory. Figured that would help a little with getting the 3 wood airborne.

            it's been 5 years since I worked with this Shaft... I can't recall
            I would soft step 1" to start.
            Monark golf says it is a low launch shaft.

            Subsonic

            I have the MCS 75 blue in my Eye 2 irons and GigaGolf forgings. A bit heavy for me but I soft - stepped them. They launch pretty good.

              colej Someone here needs this PXG driver head?!?!

              What gen is it?

                  LBlack14

                  This is GEN4 LB and I’ll pull a adapter to ship with it! If you’d like?

                  Milled MAX wedge heads are SOLD

                    Trade interest for a arm lock putter?

                    Also have a Diamana red 60 in “lite” flex that has a 1st generation callaway adapter on it. FS/Trade

                    7 days later