DonM @ode You can see it for yourself without any markings. Hold the shaft out in front of you and observe the angle of the tip. Angled up at 12:00 and installed that way, is upright. Pointed to 6 is flattest. Pointed to 9 is most closed/most loft. Pointed to 3 is most open/least loft. Assuming a RH clubhead, and a simple tip, not a double cog. Those are more complicated to see by eye.
CallMeAl The ERG V3's have the Matrix Program F15 shafts installed now. Ferrules have been turned, but waiting on grips to finish. (Arrival Late February) Same with the Kirkland Wedges. Look Great with Graphite! Gorgeous Looking Clubs! Very Happy So Far!
colej CallMeAl Those ERG heads look great. I’ve still got a set of the black ERG I haven’t done anything with yet. Might look really good with some matte black Xcaliber rapid taper shafts!
CallMeAl They're actually SOLD. So I don't want to mess with them too much. Here's a quick couple of the 5 iron and a SW. And one of the shaft...
CallMeAl My buddy decided not to wait until February for the grips. So we went with the Karma's as they were available.
Par4QC sdandrea1 They are backburnered for a few weeks, what with everything happening here. Had some time to kill so was finally able to get this one finished.
Rickochet Par4QC They are backburnered for a few weeks, what with everything happening here. Had some time to kill so was finally able to get this one finished. The T-Rex Puller. Very nice.
Rickochet Par4QC They are backburnered for a few weeks, what with everything happening here. Had some time to kill so was finally able to get this one finished. Rex, here is a pic of my JBPuller I bought from a retired FGI bud BackandWhack. I added a cutdown old grip to the pump handle. The valve has a nut over it that has been tapped for a bolt that works as a lever to open and close the valve. Using a drill bit stop collar with a bolt in it would work as well. Both are some small creature comforts using the puller. I always hated having to pull the handle out and twisting the valve open and closed with the handle end.
