FOUND!

sdandrea1

I think I’ve got a set of 6-PW 95 pulls from Taylormade heads. It’s gonna be a little bit before I get home to verify. Mom
Had her second knee replacement and it’s not going good. 2nd day in was extremely painful so we had her brought to the hospital. She’s fractured her femur.

sdandrea1 I'm going to go with 5-W based on the Internet Archive of Golfworks site :

https://web.archive.org/web/20040604155617/http://www.golfworks.com/item_disp.asp?pn=TX90WS

Shortest shaft is 37" which I assume is a W shaft; going up from there leads me to 39.5" for a 5-iron.

What's a couple of soft steps among friends?

sdandrea1 You bought them from yourself? Best $12 ever spent

sdandrea1 All PING shafts ARE .355.

But a lot of their irons will take .370, correct?

colej WTF? Not to threadjack but she went in for a knee replacement and they broke her leg???

Sorry to hear that, prayers for Momma Cole

braveheart

She’s lived with me for almost a year now. No accidents that I know of, the doctor noted she had severe deterioration in that knee and had to add some screws?

When we sat her down in the chair last night her leg was bowing inward at her knee. It was freaky looking and I said mom that doesn’t look normal to me. Then today she just couldn’t do it anymore and my wife had to catch her while my daughter ran like hell to the kitchen for a chair to slip under her.

Par4QC no, but if you dry fit one you might think it would work. Ping has some very odd hosel IDs that taper down to .355 but are VERY wide towards the top of the hosel, hence the need for the collared ferrule, although IMO it's more of a bushing ferrule or built in shim then it is a collar. If we are talking the old models that don't take a ferrule then I believe those are normal .355 taper.

ode I had a set of G5 that I sold. The guy broke a couple shafts so I cleaned the broken tips out and was going to find .355 shafts. Then I discovered that .370 would fit in 1 1/4". The graphite shafts(original) were also .370. Then while doing an online search, I came across an article that stated the bores were .370 in the later Ping irons. Seemed correct with what I had in hand. I reshafted his whole set with .370, no reaming. Just figured they were now being made like Maltby does theirs.
It's why I asked Steve about this.

sdandrea1 Just remembered that I sent a couple of the TFC shafts to @fatshot and he never said anything about them not fitting his irons.

sdandrea1 So, the newer will take .370? I can't find that article I read on it.