SMT ode hahahahaha. Or the all time funniest comment by putter designers or makers... "immediate ball roll"
azgreg SMT "immediate ball roll" Every slow motion vid of a putt I've seen shows the ball in the air and skidding a bit when it lands before it starts to roll. Every one.
Eguller azgreg Every slow motion vid of a putt I've seen shows the ball in the air and skidding a bit when it lands before it starts to roll. Every one. Yeah, that is where I have a negative AoA and chop down on it to get more backspin. 😉
Typhoon Eguller Yeah, that is where I have a negative AoA and chop down on it to get more backspin. 😉 Shooter!
d5n03 Typhoon I’m not convinced that torque in putter specific shafts is that big of a deal. I mean just how high of a swing speed does one put on a putter? Besides, torque measurement methods from manufacturer to manufacturer are not standard - pretty tough to compare as apples to apples.
Eguller I may be wrong, but it just seems a matter of heft and feel with putter shafts (assuming length, etc).
AdamMH Typhoon quick note on those weights you mentioned -- the SK is going to be roughly 3.19g/inch and the KBS is going to be roughly 3.26g/inch. In short, they'll weight the same once you cut them to length.
sdandrea1 Typhoon Why would torque even matter? You're not swinging a putter fast enough to make the head twist,even if you do hit off the toe.
Typhoon I’ll grab one and a Hypersonic this week. When I have a chance I’ll take the Scotty apart and send it to BOS to be refinished. The top line is pretty banged up
Typhoon Taki27 maybe that shaft comes I. 2 variations. One to go inside the hosel like a Anser putter and one that goes “over” the neck like that one. I know some shafts I looked at you had to specify the neck type
