Rickochet changed the title to Ping Driver Shaft Adapter Questions .

Rickochet none of the adapters require additional trimming. Pulling those are no different than any others. Shaft size doesn't matter, the adapters fit the same.

      Rickochet

      The G30 and G adapters are interchangeable. Similar to the Cobra Bio Cell, F6 and F7 adapters are interchangeable.
      I have a G30 and had a G for a short time. I have a UST Mamiya VTS shaft and it's .335 and the G30 adapter fits that fine. For awhile Ping used .350, but I believe they now use .335 stock shafts. That's been my experience anyway.

        rynobucket I have two extra adapters to sell you if interested, OEM pulls.

        Might have some interest, but they are going for $9 new shipped on ebay.

            LBlack14 Rick, I think John (Typhoon) had some extras too.

            Thanks Landon. I am seeing them on ebay for about $9 shipped.

              Yeah, someone on here bought mine. They are dirt cheap on eBay as u can see and usually free shipping. I got the 3 I had on eBay and they couldn't be told from the OEM one.

              They are all aluminum too so you don't have to worry about the ferrules melting.

              When I pulled them, used a regular puller, just put a screw and fat washer on the end to pull against.

                Typhoon When I pulled them, used a regular puller, just put a screw and fat washer on the end to pull against.

                Good news, thanks for the info. I have a JB hydraulic puller.

                  LBlack14
                  Point of clarification.....by "no additional tip trimming needed" you mean in the case of the driver....right?
                  I'm about to install an adaptor on a shaft that will go into a 5 wood. I assume that I should tip trim the shaft to make it the proper 5 wood flex before installing the adaptor.....correct?

                      Rickochet Might have some interest, but they are going for $9 new shipped on ebay.

                      No problem, I can't speak for the Ping adapters on the bay, but I know some other adapters fall under the category of 'you get what you pay for'. I have a few TM adapters that the markings are significantly off (STD loft is actually +/- .5*)