What did you build today?

DonM · 2020-01-24T22:58:56+00:00

I'll start. Vertex AW on SK Fiber TT75R shaft. Cleveland Launcher HB 5W on UST 55 Gold R shaft.

Walterjn

CallMeAl I do add a little bit of beads. Mostly I take a flat 'toothpick' and use the wide end to get some to mix in. Never bothered trying to weigh it all.

CallMeAl

Walterjn

Nobody I play with is that sensitive!

I'll weigh for swingweight or matching a reshaft. Shafts, grips, tape layers but not beads and epoxy.

Walterjn

CallMeAl my golfworks beads say 3-5% by volume. Not sure I get that close at all.

CallMeAl

Walterjn

I actually use sandblast beads. Started using them Years Ago! Got'm from work while sandblasting heads/faces.

Now I have a couple bottles of my own. More than enough to last me the rest of my time.

Rickochet

Walterjn my golfworks beads say 3-5% by volume. Not sure I get that close at all.

Just put a small pile of beads on a small paper plate. After putting epoxy on the shaft just touch the tip of the shaft at 45° on two sides then put it into the shaft and spin it a couple of turns. Then with a small crease on the edge of the plate you can put the left over beads back in the bottle.

Typhoon

Yeah Ode, I’m done with the double syringe. It came with the plunger not the gun but the tip of the string gets yucky, you put the cap on and it has both parts epoxy on it… it’s just a mess. The plunger I have to press it against my chest for it to come out or take one side of the plunger and do one side at a time… and that’s after I heat it up a bit so it flows better.

I did the one adapter today. I don’t do much so I’d rather get the smallest and cheapest individual bottles I can going forward.

I have a HOF Express stiff I wasn’t going to put an adapter on but now I think I might. I have a few people at indoor golf that have Taylormade drivers I could sell it to.

Walterjn

ode I have one, it is so much easier than the way I was doing it. I was using some dowels and a straight board as a syringe.

Walterjn

CallMeAl good to know I can always raid the blast cabinet in a pinch. Will need to clean the beads I pull out of there. That shouldn't be too difficult.