Par4QC Keep in mind who you are talking to. If I want that adapter to fit the 455DB head, it most certainly will. 😲🤣

Of course. WTF was I thinking? 😂

    Got Jake's old clubs, 4-AW -TM Rocketbladez, and was going to clean them up and sell them for him. They cleaned up OK, as far as 12 yr. old irons go, but I noticed a bent tip on the 5i. Then checked them all and decided to pull the shafts and just sell heads only. ALL the tips were bent!
    Then of course, with all the extra iron shafts I have....enough that I should just do a new fence around the back yard.... decided to just rebuild the clubs and try them out. All done with the build.

    I think that may ruin any posting in the 'what did you buy this week?' thread, for me.😅

      Have been getting along so damn well with the HOF Code 5 in my driver that I decided to reshaft my Exotics C721 3HL (4 wood) last night with a HOF Code 6. Curious to see how it performs.

        Put together a new Juggernaut Max 3 wood with a Paderson shaft. Didn't tip the shaft so we'll see if it plays too soft. Also put a FGI Plus shaft in a new I-Win Single Lengthy Hybrid, 7 iron length.

          ode Curious your thoughts on this puppy!

          Well it is the only club that I own that has gotten me “on in two” on a par 5 for quite a long time…and it happened twice in the same round a little over a month ago…so of course I needed to reshaft it…🤣🤣

          But I keep switching back & forth between this C721 and a C722 adjustable 5 wood with Ventus Red…still trying to decide which one will stay in the bag.

          C721 seems to suit my need a little better from the short grass due to its shallower face…I think the E722 also has a shallower face than the C722.

          Took this C721 to the range for a quick session last night with the HOF Code 6 in it (built to 42.5”) and it may just be the winner…just need to test it on the course during my next round to confirm.
          It felt pretty damn good…sent several range balls straight down the target line that seemed to roll out just up to & slightly past the 200 yd sign…still would like to see a little more trajectory but I think I was delofting it a bit too much at setup/impact and the ball placement may have been a little too far back as well…those finicky FW off the grass things ya know…😂

            Eguller Maltby TS3 heads arrived and test mule 7i assembled with an XCaliber RT shaft. Ready to rock. 🏌

            Set build complete, and first round tested.

            Over the years, I've played a number of forged blades & cavity backs and I have to say these can hang
            with just about any of them. With the RT shafts, they feel as good as you could hope and easy to flight
            and hit partial or full shots. Very impressive overall. In fact, for the time being they have moved the
            P790's out of the bag. 😳 Not bad lookers either. 😉. I'll update when I get a chance to hit them again.

              Worked on some garage left-overs this morning.
              Geek Fail Safe 3 on Paderson Kinetixx shaft.
              Recently re-re-re-acquired Golfsmith P2 on Wishon Interflexx, with a couple of Xcaliber Pro95s on 9i and PW when I ran out of Wishons.
              Inazone 54/60 wedges on TT Scores.
              Decided not to reshaft the C-Ray head just yet.

              Playing Monday, so I may go FGI/GEA retro that day.

                Put this together earlier in the week. Played it yesterday and very happy with it so far. Maltby moment X tour.