Rickochet I still do also. I know before I epoxy the shaft into the adapter as to where I want it set. I never change the setting after that. I have tried a different setting a couple times this summer, but only had to move the shaft less than 1/4, and it worked OK. If I want a different setting than what I started with, I usually just put an adapter on another shaft, of the same model. I seem to have plenty. π
Rickochet a sheet wrapped graphite can have bigger spines which can make the effective flex vary based on installation orientation
I've got one here that I had a hell of a time turning in the spine finder. Thought it was going to snap my wrist when it did flip! May be the best shaft I've used. A lot of those NV Green shafts were like that, in the beginning. And I really liked them.