Hoss7504

I've already found that some of DTG's trim charts are wrong in comparison to other manufacturers as well. I've actually inquired about it with no response. What I've found on the KK Black 60 shafts is...
1/2" - 3w
3/4" - 5w
1" - 5w and up

I'm not sure what shafts those are exactly except a "black" model because of the color of the lettering.

      LBlack14 I've already found that some of DTG's trim charts are wrong in comparison to other manufacturers as well. I've actually inquired about it with no response.

      Had they correct their trim chart , if they did not dispute your finding ?

          Release Nope. I was checking some hybrid shafts they had. I posted here somewhere and to the best of my knowledge, nada.

              LBlack14

              Also a common practice in the hobbyist circle that some do not tip trim their wood shaft. Which, for the most part would not influence the user's performance one tiny bit.

                  Release If you're saying a non tipped 3w shaft vs same shaft tipped 1" for same head won't perform different, I beg to differ.

                      LBlack14

                      Of course it would be different, but to many of the golfers they would not know the difference .
                      Some of us could tell the slightest change in a golf club, for the most of the golfers, they could not tell.

                          LBlack14

                          Good that we have the inquiring mind like you to keep everyone honest. 😃

                            Tim Hewitt said many times that graphite shafts today ( this was 6-7 years ago) are so stable in the tip that they do not require tip trimming like in the days gone by. He would joke that companies would actually publish them because if they didn't that people wouldn't believe them and they would be flooded with calls asking what the tip trim was.

                            so unless you really load the shaft at impact , are strong with a very fast swing speed such that you find that untipped provides too much launch angle, no need to tip. ( my experience as well) remember trimming shafts at the tip is for trajectory control

                              Weirfan Tim Hewitt

                              Do you know if he is still enjoying his retirement in Malaysia ?
                              Real Estate and currency exchange over there had taken a beating recently, might be better off for someone whom is drawing retirement and pension from here but lives over there.

                                  Release
                                  I don't, last I heard he was writing novels and doing well.

                                    Hoss7504

                                    That would be a good experiment.
                                    Save a half an inch on the butt end so later on you could trim the tip to length or trim the butt to length after you tried it out.

                                      9 days later

                                      I reshafted the 3W w/o tip trimming and it worked great. Doesn't feel soft or anything. I think I'll trim 1/2" for the 5W though, just in case.

                                        Hoss7504

                                        Don't do it, if you like the 3 wood without tip trim.
                                        Leave the 5 wood shaft 3/4" longer than you like. If it's too flexible then pull the shaft and tip off 1/2".
                                        If it play good ( which I think will be the case ) then blow off the grip and trim to length .

                                        I had seen both in sets of fairway woods and hybrids where the flex played different, because of the what you're thinking of. 5 wood will be shorter than the 3 wood so it'd play stiffer with shorter length anyway.

                                            Release

                                            Good call. Thanks for the advice! I'll be putting all that together over the weekend and hoping for the weather to start cooperating 🌅

                                              If I recall correctly, I think I saw on Amazon Tim is now in North Carolina