I have a Taylormade r580XD "TP" head looking for a new shaft. The head is .335 diameter. Regular or soft stiff. Should play at 44.5 to 46" .
Looking to stay under $35 shipped to 97760. Thanks!
Gary - are you sure it's .335? I thought all TM was .350. Maybe because it's TP?
Never mind...............I looked it up. TP's are .335😀
sdandrea1
TP's are .335 Shame on you.
LBlack14
I know, right? The TPs had all the custom shaft offerings. Getting senile.
Steve, I had to double check on it. But apparently they went with .335. It's a great head. I had a Project X 5.5 in it that just wasn't right...
gllama
It's a great sounding head. All those 580 and 540 heads were solid. I checked the Golfworks replacement guide and then remembered that I used to know the TPs were all .335 My disk ran out of space. I need to defrag............
It's a great head. Maybe not the most forgiving but if your swing is on, it's as long as any driver I've hit. But the key is finding the right shaft. I find it similar to the Orlimar Hip Ti 420. What a great old school head...
Hey G. That is a very solid head....I have lots of Reg./Soft S shafts that I can check tomorrow morning and get a list to you if you are still looking.
Are you partial to any specific one ? Enjoy the rest of the season. D.
Hi Dan. I'm pretty much open. I'm 62 now with a bad hip but can still pop it out 250-260 on a good day. Used to be around 105 swing speed but now down to maybe 95-98. Used to love the Aldila NV65. Now need a higher launching shaft. Send me what you have. Thanks.
Grafalloy Blackbird. Nice shaft at a bargain price. I have a couple of these and they are very nice and not overly stiff. From what I read I think you will be ok with an R flex.
https://www.monarkgolf.com/golf-components/shafts/graphite-golf-shafts/grafalloy-blackbird-45-graphite-wood-shafts.html
I have a brand new Grafalloy Pro Launch Blue shaft, still in the wrapper, regular flex with the following specs: Butt Diameter .600 Tip Diameter .335 Weight 64 gm Length 46" Bend Point Med/Low Tip Stiffness Med/Soft
$35 shipped
Hammer4413 Thanks Bill, it's a consideration.
Rickochet Thanks!
PM sent Gary.
Eguller Dan, how do I get PM messages? Not sure where to look on this site. Can't find it anywhere. You can just email me direct at: crookedrivergar@gmail.com Thanks!
gllama Eguller Dan, how do I get PM messages?
Go to a post from the other person and hover the cursor over his name and you will get a pop up window with three vertical dots on the right side. Click on the dots and you will get a link to send a PM. It is not a message that he will get in his email. It will be a private post on the forum that only you two will see. He has to know to look for it. Awkward indeed but better than nothing.
Rick, maybe I'm old and slow (entirely probable) but I just want to retrieve a PM that Dan sent me. Can't find it. You're right, very awkward.
gllama Rick, maybe I'm old and slow (entirely probable) but I just want to retrieve a PM that Dan sent me. Can't find it. You're right, very awkward.
Maybe look on the Buy/Sell Forum main page and their might be a private thread posted by Dan.
I gave him my email in a post so maybe he'll see it and respond. Really awkward site, but it's free so I appreciate it and the people who run it. Thanks Rick.
PM will show as another thread to you only.