I bought a set of pullout graphite iron shafts on ebay. They were too short so I bought some extenders. I found these on ebay but also found the vendor's website. I ordered the graduated gauge first. You poke it down the shaft until it stops and it shows what color coded extension. It turns out I needed the yellow ones (.515"). I glued these in yesterday and the fit like a glove. Very heavy duty as well. This may not be the cheapest way to extend shafts but man, it sure was easy.
I have that gauge as well, its very helpful for graphite shafts for sure!!
Coachsb I have that gauge as well, its very helpful for graphite shafts for sure!!
Hi Steve, welcome back. I hope all is well. 👍
thanks Rick, its going, sometimes well, sometimes not, but its going
Great to see you post, Coach!! Thought you were gone from here for good. All my best to you and yours!
That is a very slick looking product line. I've also seen it in either Hireko or GW, but have not used it.