Long shot, but I’m looking for a Ping TFC100 iron shaft pull…..either 8-9-W Regular flex or Soft Regular flex.
I have two of these in my wedges already, and would like to get another one to reshaft my gap
wedge. If anybody has an old one laying around that you want to get rid of, send me a PM please….

    Those were the shafts used in PING G5 irons. Useless trivia that gives no help to your quest but adds to my ridiculously high post count. 😎

    fatshot
    These came from G5 irons. Label shows they are the 5, 7, 9. But the lengths don't match those, imo.
    The pic lengths are with grips on when taken but I have removed them now.

    The best thing about these shafts are the pricing in Illinois tonight🤣. Pre-Spring special of no money down, no payments ever. All with free shipping....to an address near you.

    edit: Upon closer inspection, the longest shaft is no good, has a 'micro' crack at the tip. It has been put with the trash.


        Par4QC Wow Rex, Thank you! I’ll gladly pay shipping…..

            sdandrea1 Party of the 1st part(you) head-slapped the party of the 2nd part(me) into remembering I had these shafts. I had read the OP prior, but it just didn't ring the bell.

                Par4QC The tunnel has only reached SE IA so far.😂

                Maybe when you take the left fork…what about the right? 🤣

                Dammit duh…I fixed it…you & Al are fairly close 😜

                    CallMeAl Spickard.
                    After checking the map again, he may be closer to me than you, or about equal distance. And you are closer to me than him.