pike51 Any tricks to removing the Club Conex Faz-Fit adapters from driver heads? I have a couple SMT heads I want to take these out of and just want to check before I proceed. TIA.
Jelopster I took one off a Ping Glide 2 wedge. Just took some heat. Just be aware that sometimes the hosel is cut to accommodate the adapter. That was the case with my Ping (it was a fitting head). There was enough hosel depth left to shaft without issue and it plays fine.
Luc_Van_Daele Beware that the conex system adds some 10gr to the clubhead, so the clubheads may be altered in some way (cut hosel, drilled,...) to make them 10gr lighter then standard.
